Intended Use - Makita DPO500 Manuel D'instructions

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Backing pad diameter
Orbits per minute
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for polishing.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-4:
Model DPO500
Sound pressure level (L
Sound power level (L ) : 93 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Model DPO600
Sound pressure level (L
Sound power level (L ) : 94 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Normal mode
Finishing mode
) : 82 dB(A)
pA
) : 83 dB(A)
pA
DPO500
123 mm
BL1815N / BL1820 / BL1820B / BL1830 / BL1830B / BL1840 /
BL1840B / BL1850 / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the tool is
used especially what kind of workpiece is processed.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (tak-
ing account of all parts of the operating cycle such
as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-4:
Model DPO500
Work mode: polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model DPO600
Work mode: polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
5 ENGLISH
DPO600
148 mm
-1
0 - 6,800 min
-1
0 - 5,300 min
530 mm
D.C. 18 V
3.1 - 3.6 kg
2
) : 9.5 m/s
h, P
2
2
) : 10.0 m/s
h, P
2