AYA ACT1000A+ Instructions D'utilisation page 22

① Screw
② Low Hinge
③ Adjustable Low Foot
④ Adjustable High Foot
⑤ Upper Hinge
⑥ Screw Bolt
⑦
Upper Hinge Cap
⑧
Shaft Sleeve
⑨
Plug
1. Remove the upper hinge cap (7).
2. Remove the two screws blot (6) that connect the upper hinge (5) on the right
side of the cabinet top.
3. Carefully lift the door and place it on a padded surface to prevent scratching.
4. Remove the plug (9) and transfer it to the uncovered hole on the right side
of the unit. Be sure to press the button firmly into the hole.
5. Remove the two screws(7) that hold the lower hinge (2) on
the right side of the unit.
6. Remove the screw-type leveling front leg (4) and transfer it
to the right side as shown in the adjacent figure.
7. Set the door into it's new place making sure the pin enters
the bushing at the lower frame section (hole).
- 19 -