AYA ACT1000A+ Instructions D'utilisation page 28

The appliance may not be connected to the mains during cleaning. Danger of
electrical shock! Before cleaning switch the appliance off and remove the plug from
the mains, or switch off or turn out the circuit breaker or fuse.
Never clean the appliance with a steam cleaner. Moisture could accumulate in
electrical components, danger of electrical shock! Hot vapors can lead to the
damage of plastic parts.
The appliance must be dry before it is placed back into service.
Ethereal oils and organic solvents can attack plastic parts, e.g. lemon juice or the
juice from orange peel, butyric acid, cleanser that contain acetic acid.
Do not allow such substances to come into contact with appliance parts.
Do not use any abrasive cleansers.
Remove the food from the freezer. Store it in a cool place, well covered.
Switch the appliance off and remove the plug from the mains, or switch off or turn
out the circuit breaker or fuse.
Clean the appliance and the interior accessories with a cloth and lukewarm water.
Commercially available dish washing detergents may also be used.
After cleaning wipe with fresh water and rub dry.
Accumulation of dust at the condenser increases energy consumption.
For this reason carefully clean the condenser at the back of the appliance once a
year with a soft brush or a vacuum cleaner.
After everything is dry place appliance back into service.
1. Do not place warm foods into the appliance. Allow warm foods to cool first. Do
not install the appliance near cookers, radiators or other sources of warmth.
High ambient temperatures cause longer, more frequent operation of the
compressor.
2. In order to make the cooling system work efficiently, please make sure the side
plates and back plate of the product are with some distance from the wall. It is
strongly recommended that its back is 75mm away from the wall, its sides at
least have a space of 100mm separately and the height from over its top is not
less than 100mm.
3. When the product works, please do not open the door too often or leave the
door open any longer than necessary.
4. Do not set temperature any colder than necessary.
5. The direct cooling freezer (with a freezer) needs to be defrosted when
necessary. This will improve the cold transfer and reduce energy consumption.
6. The sketch map shows the right combination of the drawers, which can lead to
the more energy efficiency. If users adjust the combination, it would result in the
energy-consuming.
7. Store food logically. Do not exceed the storage period specified.
- 25 -