Table des Matières
Publicité
Troubleshooting
Problem: Remote control does not work.
Cause: The ON/OFF-power switch is
turned "OFF".
Solution: Turn the ON/OFF-power switch "ON".
Cause: The batteries have been wrongly
inserted.
Solution: Check if the batteries have been
correctly inserted.
Cause: The batteries do not have enough
power.
Solution: Insert new batteries.
Problem: The Quadrocopter cannot be con-
trolled with the remote control
Cause: The power switch on the remote
control is turned "OFF".
Solution: First turn the power switch on the
remote control "ON".
Cause: The remote control is possibly not
correctly frequency bound with the receiver
on the Quadrocopter.
Solution: Please carry out the binding pro-
cedure as described in "Checklist for flight
preparation".
Problem: The Quadrocopter does not start.
Cause: The ‚Start rotors' button has not
been pressed on the controller.
Solution: Press the ‚Start rotors' button on
the controller.
Problem: The Quadrocopter does not lift.
Cause: The rotor blades rotate too slowly.
Solution: Slide the gas lever up.
Cause:
The battery´s power is not sufficient.
Solution: Charge the battery (see chapter
"Charging the battery").
Problem: During flight, the Quadrocopter
loses speed and height without any obvious
reason.
Cause: The battery is too weak.
Solution: Charge the battery (see chapter
"Charging the battery").
Problem: The quadrocopter only flies in a cir-
cle or turns over on starting.
Cause: Rotor blades incorrectly fitted or
damaged.
Solution: Fit rotor blades / replace rotor
blades as described in
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
23
ENGLISH
.
21
22 23
Publicité
Table des Matières
