GYS PRESS 10T PUSH-PULL Mode D'emploi page 20

After punching the punch is pushed into the metal sheet
and pierces the hole. The sheet is free from the punch
and ready for riveting.
INSTALLATION OF FLOW FORM RIVETS
Once the starter hole is done, insert the Flow-Form rivet:
The F2 matrix has got an evacuation hole for glue resi-
dues. After each use, remove all the glue residues on the
tools.
If the punch does not come out of the sheet metal, use
the PULL function of the riveter.
Press the PULL button and squeeze the trigger.
Once the punch is out of the sheet metal, press the
PUSH button.
20
GYSPRESS 10T PUSH-PULL
Before assembling metal sheets with Flow-Form rivets, it is necessary to pre-drill the metal (see
the procedure above).
The end piece F1 must be on the head rivet side:
RESULT OF THE INSTALLATION OF A FLOW-FORM
RIVET
EN