Menu Options; Menu Selections; Recall Of Stored Data; Setting Date And Time - Lovibond MiniDirect Mode D'emploi

Menu options

GB
Mode
On
Off
!
Store Date
2
1
3 4
Time Cal
Mode
Zero
Test
Mode
!
Mode
SET
DATE
YYYY
(2 sec.)
Mode
Zero
Test
!
MiniDirect_ClpH_1 09/2008

Menu selections

Press the [MODE] key and hold .
Switch the unit on using the [ON/OFF] key .
Allow the 3 decimal points to be displayed before releasing the
[MODE] key .
The [!] key allows for selection of the following menu points:
recall stored data
1
setting the date and time
3
2
user calibration
4
The selected menu is indicated by an arrow in the display .
Confirm the selection with the [MODE] key .

Recall of stored data

1
The photometer shows the last 16 data sets in the following format
(automatically proceeds every 3 seconds until result is displayed):
Number n xx (xx: 16 . . .1)
Year YYYY (i .e . 2008)
Date mm .dd (monthmonth:dayday)
Time hh:mm (hourhour:minuteminute)
Test Method
Result x,xx
The [ZERO/TEST] key repeats the current data set .
The [MODE] key scrolls through all stored data sets .
Quit the menu by pressing [!] key .
3 Setting date and time (24-hour-format)
2
After confirming the selection with the [MODE] key the value to be
edited will be shown for 2 sec .
The setting starts with the year (YYYY) followed by the actual value
to be edited . Same applies for month (mm), day (dd), hour (hh) and
minutes (mm) . Set the minutes first in steps of 10, press the [!] key to
continue setting the minutes in steps of 1 .
Increase the value by pressing the [MODE] key .
Decrease the value by pressing [ZERO/TEST] key .
Proceed to the next value to be edited by pressing [!] key .
After setting the minutes and pressing the [!] key the display will show
"IS SET" and instrument returns to the measurement mode .
29