Sauder Costa 419954 Mode D'emploi page 27

Step 23
1
D24
V
Groove
Insert the SMALL DRAWER SIDES (D24 and D25)
å
at an angle into the slot at each end of the SMALL
DRAWER FRONT (V).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
NOTE: The SMALL drawers will only use two SCREWS per drawer. Refer to the diagram.
å
Fasten the SMALL DRAWER BACK (D109) to the SMALL DRAWER SIDES (D24 and D25). Use two BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the SMALL DRAWER BOTTOM (D716) inserts into the groove of the SMALL DRAWER BACK (D109).
å
Repeat this step for the other SMALL drawers.
å
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D25
D109
D24
D716
VIEW THE T-LOCK BOX VIDEO
2
D24
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the SMALL DRAWER BOTTOM (D716) into the
å
grooves in the SMALL DRAWER SIDES (D24 and D25)
and SMALL DRAWER FRONT (V).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D25
NOTE: Do not use this hole
in the SMALL drawers. This
hole will be used in Step 25.
419954
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
s u r
e d
f a c
e
D716
D25
V
30S
(8 used in this step)
Page 27