Step 11
Separate the EXTENSION SLIDES (40NC) from the EXTENSION RAILS (40NA) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten eight EXTENSION RAILS (40NC) to the ENDS (A and B) and UPRIGHTS (D and E). Use sixteen GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and UPRIGHTS. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES (40NC) will be used later for the SMALL DRAWERS and PENCIL DRAWER.
å
GOLD 5/16" FLAT HEAD SCREW
(16 used in this step)
3
2
1
2
1
Open end
1
Open end
www.sauder.com/services
40NC
Push the black lever in and pull the SLIDE from the RAIL.
3S
4
4
3
B
4
3
4
2
3
2
1
D
1
2
1
3
2
4
3
4
A
2
3
4
3
4
419954
40NA
Open end
Open end
1
1
2
E
Page 15