Step 10
Separate the EXTENSION SLIDES (40MA) from the EXTENSION RAILS (40MC) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40MA) to the ENDS (A and B) and UPRIGHTS (D and E). Use eight GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the ENDS and UPRIGHTS. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES (40MC) will be used later for the LARGE DRAWERS.
å
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
Edge with
TWIST-LOCK®
FASTENERS
P
Open end
Page 14
40MC
B
4
3
2
1
D
4
3
2
1
H
A
3
4
E
419954
40MA
Open end
1
2
Edge with
TWIST-LOCK®
FASTENERS
H
1
2
3
4
www.sauder.com/services
Open end