Altrad BELLE PORTO SCREED Manuel De L'opérateur page 10

Masquer les pouces Voir aussi pour BELLE PORTO SCREED:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
GB
Note that the machine is a two man lift operation. Never attempt to carry the machine on your own. Always seek assistance with
lifting and transporting the Porto Screed.
start the engine.
vibration, set the throttle to maximum.
Never force the machine, always allow it to travel at its own pace.
Always make sure that no person or obstruction is in your line of travel. Watch your step to avoid tripping.
USE extreme caution and be observant when working in close quarters or congested areas.
Hints on Concrete Screeding.
with two end handles or rope handles which are attached to the end frames. These are for two man operation of the porto screed.
The machine will travel with its own momentum with only a little assistance from the operator.
raked away.
4. If a second pass is required the Porto-Screed should be guided quickly over the slab without stopping to avoid ridges.
GB
MAINTENANCE
The Belle Group Porto Screed is designed to give many years of trouble free operation. It is, however, important that the simple
regular maintenance listed in this section is carried out. It is recommended that an approved Belle Group dealer carries out all major
maintenance and repairs. Always use genuine Belle Group replacement parts, the use of spurious parts may void your warranty.
Before any maintenance is carried out on the machine, switch off the engine and disconnect the HT lead from the sparkplug.
Running In Period
minutes of use.
Drive Belt.
four nuts holding the bearings in position. Slide the bearings away from the engine and retighten the four nuts. Once set, check the
belt tension a second time. Then check the pulley alignment. If the alignment is incorrect, loosen the taperlock bushes and move the
pulley to suit. Once the pulley is aligned, retighten the taperlock bushes. Finally, replace the belt guard ensuring it is correctly and
Routine Maintenance
Engine Oil
Check Level
Change
Air Filter
Check Condition
Clean / Replace
Spark Plug
Check / Clean
Drive Belt
Tension
Oil / Fuel Type & Quantity - Spark Plug Type
Petrol Honda GX120
Operating Instructions
Servicing
Oil type
Quantity
(Litre)
Fuel Type
Capacity
(Litre)
10
Spark Plug
Electrode
Type
Gap (mm)

Publicité

Table des Matières
loading

Table des Matières