Installation Instructions - L.B. White Sun Blast HD Manuel Du Propriétaire Et Instructions

General Installation Instructions
WARNING
Burn Hazard
Can cause property damage, severe injury or death.
1. To avoid dangerous accumulation of fuel gas, turn
off gas supply at the appliance service valve before
starting installation, and perform gas leak test after
completion of installation.
2. Do not force the safety control valve's button. Use
only your hand to depress the button. Never use
any tools. If the button will not operate by hand, the
control should be replaced by a qualified service
technician. Force or attempted repair may result in
fire or explosion.
1. Read all safety precautions and follow L.B. White
recommendations when installing this heater. If
during the installation or relocating of heater, you
suspect that a part is damaged or defective, call a
qualified service agency for repair or replacement.
2. Station or hung the heater properly before use.
Use a level to ensure the heater is position or
hung perfectly vertical and has zero angle in any
direction.
3. The heater must be installed on a level, flat,
horizon and stable surface when hot or in
operation and according to minimum clearances
from combustible surface such as walls, floor, or
ceilings. Do not place combustible materials within
this zone of clearance. See Specification Page
4 of this manual for minimum safe distances to
combustible materials
■ Per OSHA 1926.154: a heater not suitable for use
on a combustible surface may be used on such
surfaces providing the heater rests on a suitable
heat shielding and insulating material, such as
concrete, of at least 1 inch (2.54cm) thickness. The
insulating material shall extend beyond the heater
2 feet (0.61m) or more in all directions.
4. L.P Gas Installation Requirements
■ Ensure all L.P. gas containers are secured and
protected from people, vehicular traffic and contact.
■ L.P. gas containers must be located on a flat,level,
and stable surface.
■ L.P. gas cylinders (100 lb./45kg cylinders/tanks)
must be secured from tip-over.
Contact your local authorities, L.P. gas dealers, or
fire marshalls for specifics dealing with installation
in your area.
5. Position the heater and its gas supply hose so
as to protect heater and its gas supply hose
from traffic. Protect hoses with a shielding
device of suitable nature to protect the hose
from traffic and movement or other construction
equipment.
6. The heater shall be installed so it is not directly
exposed to water spray, rain, and /or dripping
water.
7. The heater's gas pressure regulator must be
protected from adverse weather conditions (rain,
ice, snow) as well as from building materials
(tar, concrete, plaster, etc.) which can affect safe
operation and could result in property damage
or injury.
8. Heaters used in the vicinity of combustible
tarpaulins, canvas, plastics, wind barriers, or
similar coverings shall be located at least 10
feet (3.05m) from the coverings. The coverings
shall be securely fastened to prevent ignition or
upsetting of the heater due to wind action on the
covering or other material.
9. Check all connections for gas leaks using
approved gas leak detectors. Gas leak testing is
performed as follows:
-- Check all pipe connections, hose connections,
fittings and adapters upstream of the gas control
with approved gas leak detectors.
-- In the event a gas leak is detected, check the
components involved for cleanliness and proper
application of pipe compound before further
tightening.
-- Further tighten the gas connections as
necessary to stop the leak.
-- After all connections are checked and any leaks
are stopped, turn on the main burner.
-- Stand clear while the main burner ignites to
prevent injury caused from hidden leaks that
could cause flashback.
Owner's Manual • Sun Blast HD
Sun Blast HD
9