Lighting Instructions; Shut-Down Instructions - L.B. White Sun Blast HD Manuel Du Propriétaire Et Instructions

12
Sun Blast HD

Lighting Instructions

1. For Propane gas use, slowly open the gas supply
container valve. (This prevents lockup of the excess
flow check valve internal to the regulator's POL
fitting.)
2. Ensure the thermostat knob on the gas control valve
is turned to its HIGHEST (position 7) setting.
See Fig. 5.
3. Rotate the gas control knob to the IGN position and
firmly push it in. While holding it down, continue to
turn the knob to the PILOT position.
4. With the gas control knob pushed in, press the igniter
button repeatedly to light the burner.
FIG. 5
IGNITER BUTTON
THERMOSTAT
KNOB
■ On new installations it may take a short time for gas
to purge out any air before the burner lights.
5. Keep the valve button depressed for about 30
seconds to allow the thermocouple to warm up.
6. Release the safety control valve button.
7. Once the burner is lit, position the thermostat knob to
the desired setting or between 1 and 7.
Owner's Manual • Sun Blast HD
GAS CONTROL
KNOB

Shut-Down Instructions

1. Close the propane gas supply container valve.
2. Allow the heater to burn off any fuel gas remaining in
the gas supply line.
3. Position the thermostat knob to its lowest setting
(position 1). See Fig. 6.
FIG. 6
IGNITER BUTTON
THERMOSTAT
KNOB
4. Turn the safety control valve's knob to the OFF
position. See Fig.6.
5. Disconnect the heater from its gas supply.
GAS CONTROL
KNOB