Replacing The Lamp - KÜPPERBUSCH IKEF329-0 Notice D'utilisation

Problem
The lamp does not work.
The Pilot light flashes.
The compressor oper-
ates continually.
The compressor does
not start immediately af-
ter pressing the Super-
cool button, or after
changing the tempera-
ture.
Water flows on the rear
plate of the refrigerator.
Temperature cannot be
set .
The temperature in the
appliance is too low/
high.
The temperature in the
refrigerator is too high.

Replacing the lamp

1. Disconnect the mains plug from the
mains socket.
2. Press on the rear hook and at the same
time slide the lamp cover in the direction
of the arrow.
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The appliance is not working
properly.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
The compressor starts after a
period of time.
During the automatic defrosting
process, frost defrosts on the
rear plate.
Supercool function switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Contact a qualified electrician.
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
This is correct.
Switch off Supercool manually, or
wait to set the temperature until
the function has reset automati-
cally. Refer to "Supercool func-
tion".
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light lamp cover)
4. Install the lamp cover by sliding it into its
original position.
21
Solution