Replacing The Lamp - KÜPPERBUSCH IKE257-7-2T Notice D'utilisation

22
Important! There are some sounds during
normal use (compressor, refrigerant
circulation).
Problem
The appliance does not
operate. The lamp does
not operate.
The lamp does not work.
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.

Replacing the lamp

1. Disconnect the mains plug from the
mains socket.
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
2. Remove the screw from the lamp cover.
3. Remove the lamp cover (refer to the il-
lustration).
Solution