Hoover SmartWash Pet Complete Guide D'utilisation page 20

Tools and Accessories
Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the cleaner from falling, always place cleaner
at the bottom of stairs or on floor. Do not place cleaner on stairs or furniture, as it may result in injury or damage.
Cleaning Carpeted Stairs and Upholstery
1
Read "Before you Begin Cleaning" instruction
on page 9.
2
Attach hose as instructed (page 18).
3
Place handle in upright position. FlexForce™
PET PowerBrushes will not rotate while
handle is in the upright position.
4
Fill Clean Water Tank according to
instructions.
5
Fill Solution Tank with HOOVER® solution
according to instructions on page 10.
6
Attach tool to end of hose.
7
Dry hands and plug cleaner into a properly
grounded outlet.
8
Turn cleaner ON.
20
CAUTION
9
Pre-spray the area by holding the
tool about one inch above the carpet
and push it forward while pressing
the trigger.
10
Slightly press the tool switch into
area cleaning. Press the trigger and
pull the tool slowly over the carpet.
Release trigger at end of stroke.
11
Lift tool, and position it against
Nozzle. Pull tool slowly over carpet
without pressing trigger.
12
Overlap strokes by ½ inch to help
prevent streaking.
13
It is best to alternate wet and dry
strokes as described in steps.
9
11
Tips
To avoid saturating carpet, do not use
more than 4 wet strokes over any one
area. Always end with dry strokes.
If additional cleaning is necessary, wait
until the carpet is completely dry before
using the tool again.
Empty Dirty Water Tank when the motor
sound beccomes higher pitched and
there is a loss of suction. You will also
see the float rise and shut off suction at
the same time.
When finished cleaning, follow "After
Cleaning" and "After Using Tool"
instructions.