Installation; Preliminary Checks - entrematic Ditec PWR25H Traduction Des Instructions D'origine

6. Installation

The declared operating and performance features can only be guaranteed with the use of EN-
TREMATIC accessories and safety devices.
Unless otherwise specified, all measurements are expressed in mm.

6.1 Preliminary checks

Check that the structure of the gate is sturdy and that the hinges are lubricated and function smoothly.
If possible, provide an opening and closing stop, otherwise use the integrated mechanical stops
and/or the electric limit switch (optional) if available. The mechanical parts must be in accordance
with the provisions of the EN12604 standard.
The fixing point of the automation varies depending on the space available and the gate to
i
be automated, therefore it is up to the installer to choose each time the best solution to
ensure the correct operation of the system.
The installation measurements indicated in the table allow to choose the values of [A] and [B] on
the basis of the desired opening angle and in relation to the on site spaces and overall dimensions.
Increasing measurement [A], you reduce the opening approach speed.
Reducing measurement [B], you increase the degrees of gate opening.
Measurements [A] and [B] must, however, be compatible with the effective stroke of the piston.
Tab. 6.1
A
90
110
150
PWR25H
130
110
100
90
130
150
PWR35H 130
130
110
100
D
B C
160 50
160 50
130 50
150 70
180 100
190 110
190 50
190 50
190 50
180 70
210 100
260 150
280 200
A
P
min 60 con apertura a 90° min. 60 with 90° opening
S D
110 95°
110 100°
80 110°
80 90°
80 90°
80 90°
140 95°
140 100°
140 110°
110 90°
110 90°
110 90°
80 90°
30
E L
90 700
110 850
P
min
110
120
160
140
120
110
100
140
160
140
140
120
110