Mettler Toledo PS7 Mode D'emploi page 11

5.3 Select formula weighing method
C.o.r.r.0.?
Mode
Enter
S. T
C.o.r.r.0.?
Mode
Enter
A. D
Mode
Enter
A. D . V . . A . B . S . . E . 1 .
Mode
Enter
A. D . V . . A . B . S . . E . 1 .
Mode
Enter
5.4 Terminating and documenting formula weighing
Last
Comp
Last
Comp
Mode :STD ABS END
Components:
co01
target: 100.0 g
true : 110.0 g
co02
target: 20.0 g
true : 22.0 g
co03
target: 5.0 g
true : 5.5 g
. D . . A . B . S . . E . N . D . 8 .
. V . . A . B . S . . E . N . D . 8 .
.t.o.l.0.?
1 . 0 .
adv
% tol
.t.o.l.0.?
adv
1 . 5 .
% tol
Terminating formula weighing
Formula weighing can be terminated at any time by pressing the «Last Comp»
key and holding it down.
Documenting formula weighing
If your scale is connected to a printer, when the formula weighing is complete
you can print out the report for the formula weighing by pressing the «Last
Comp» key and holding it down.
Press the «Mode» key briefly. The formula weighing method
which was last pressed appears in the display (factory
setting: "STD ABS END").
Press the «Mode» key briefly several times to select the
desired formula weighing method (e.g. "ADV ABS END").
Confirm the selected formula weighing method by pressing
the «Mode» key and holding it down.
If you select an advanced formula weighing method ("ADV
..."), the display appears for selecting the tolerance above
which the individual components will be corrected.
Press the «Mode» key briefly several times to select the
desired plus/minus tolerance in % (no, 0.5 ... 15.0).
Note: "no" means a tolerance of zero.
Confirm the selected tolerance (e.g. 1.5%) by pressing the
«Mode» key and holding it down. The scale is then ready for
formula weighing.
Note: The selected formula weighing method remains active
until you select another.
Paint Scale PS7, PS7-X
11