Electrical Connection - EWT RUGGED3Y Mode D'emploi

Masquer les pouces Voir aussi pour RUGGED3Y:
Table des Matières

Publicité

SPECIFICATIONS
Model
EAN code
Power
Thermostat
Heat Settings
Fan Mode
Handle
IP21 Protection
Overheat protection
Anti-tilt protection
Voltage
Frequency
Product dimensions (WxDxH)
Produit weight

ELECTRICAL CONNECTION

plate) and to an electrical installation which complies with the relevant standards. Please read the safety and installation
instructions carefully prior to switching the appliance on.
INSTRUCTION FOR USE
Heat control – Switch Knob (See 2, Fig. 1)
Thermostat control knob (See 3, Fig. 1)
When the heat control is set to
Position
will turn the heater on and off to maintain a temperature of approximately 5°.
OFF
Cool Blow*
Half Heat
Full Heat
The heat output is controlled by the thermostat, according to the room temperature.
Turn the thermostat knob fully clockwise to maximum setting initially. When the room is warm
enough, reduce the setting slowly until the heater just clicks off.
The heater will now cycle on and off to maintain your selected room temperature.
An audible click may be heard when the thermostat operates - this is normal.
Note: If the heater does not come on when the thermostat is at a low setting, this is normally
because the room is warmer than the thermostat setting and is not a fault.
for cool blow, set the thermostat control (3) to maximum.
FR
EN
DE
RUGGED3Y
3 461 710 000 006
3000 W
Electromechanical
2 : 1500W / 3000W
Yes
Yes, 2 cold handles
Yes
Yes
Yes
230-240V~
W24.6 x D16.2 x H24.8 cm
2.35 kg
NL
PL
SV
11

Publicité

Table des Matières
loading

Table des Matières