Rauch KUHN QUANTRON-E Mode D'emploi page 16

QUANTRON-E/S/K Update from 01.01.2010
1. Connect USB Box with USB Stick to
Quantron E/S/K, LEDs 1 – 4 flash continuous
green; then the LEDs 1 - 4 light up continuously
for approx. 5 sec green Î transfer of the first
programme section complete, the display of the
Quantron goes dark.
2. The LEDs 1 – 4 automatically start to flash
again Î Transfer Programme Section 2 Î
After transfer, the LEDs 1 - 4 light up
continuous green for approx. 5 secs. Î
Quantron carrying out a restart
3. The LEDs 1 – 4 automatically start to flash
again Î Transfer Programme Section 3 Î
After transfer, the LEDs 1 - 4 light up
continuous green Î Quantron carrying out a
restart Î Successful completion of the update
Then you should switch the QUANTRON E/S/K off once, the USB Box should be removed
and the Quantron E/S/K should then be switched on again.
3 en