MRA 4025066170999 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
2 Fillister head screws M5 x 30mm
2 Fillister head screws M5 x 20mm
4 Plastic washer 12 X 5 x 0.5mm
2 16 X 4.5 X 4mm neoprene washer
2 15mm spacer
2 O-ring 4.5 X 1.5
Mounting the windscreen onto the motorcycle:
1. Place the motorcycle on a flat surface.
2. Dismantle the original windscreen.
3. Remove the black rubber grommets from the original windscreen and insert these at the
fastening points on the motorcycle (P1).
4. Insert the M5 X 20mm fillister head screws [10673] through the bottom drill holes of the
MRA-windscreen with the plastic washers [10635] and place the 4mm neoprene washers
[10634] against them from behind (P2).
5. Insert the M5 X 30mm fillister head screws [10566] through the top drill holes of the MRA
windscreen with the plastic washers [10635] and place the 15mm spacers [10636] against
them from behind, and secure these with the delivered O-rings [10992] (P3).
6. Now, mount the MRA windscreen onto the motorcycle (tip: First, turn all screws a few times
before carefully tightening them fully.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
DUCATI Multistrada V4 2021-
Article No..
--- Allen key 3mm
Torx TX 25
10566
10673
10635
10634
10636
10992
3
Required tools