Figure 11. Ensure Restraining Arms Are Firmly Seated Against Balustrades; Figure 12. Location Of Cleaning Head Level; Figure 13. Adjust Depth Of Cleaning Head With Fluted Knobs - HydraMaster TREADMASTER 100-100-001 Mode D'emploi

EN
6. Slide the restraining arms in their
channel to position the cleaning head
over the tread. Notice that the pin in
the end of the arm will fit into one of
the holes in the channel, locking the
arm into place. Extend the restraining
arms to their full locked position (see
Figure 11 and Figure 12).
7. Slide the TreadMaster
treadwell, making sure the restraining
arms are firmly seated against the
balustrades (see Figure 12).
8. Use the leveling adjustment knob to
ensure proper contact with the tread
surface (see Figure 11). Check the
cleaning head level to ensure proper adjustment (see Figure 11 and Figure 13).
Figure 13. Location of Cleaning
Head Level
9. Adjust the depth of the cleaning head with the fluted knobs on the cleaning head
(see Figure 14).
10. Remove the power cord, vacuum hose and warning sign from the storage
compartment.
into the
23 - TreadMaster Information and Operating Instructions
Figure 12. Ensure Restraining Arms
are Firmly Seated Against Balustrades
Figure 14. Adjust Depth of Cleaning
Head with Fluted Knobs