Inspection, Installation And Transporting; Installing New Head Assembly; Figure 2. Position Assemblies Together, On Flat Surface; Figure 3. Fluted Knobs Removed From Head Assembly; Nozzle Facing Outward - HydraMaster TREADMASTER 100-100-001 Mode D'emploi

EN

INSPECTION, INSTALLATION AND TRANSPORTING

INSPECTING ASSEMBLIES
After receiving your TreadMaster, carefully unpack the boxes and inspect the housing
assembly, brush and head assembly for shipping damage.
No matter which TreadMaster configuration you order (see Table 1 and Table 2 on pages
36 - 37), you can receive up to three major assemblies in your shipment unless you
specify otherwise:
1. Soft Brush for Painted Escalators
2. Housing Assembly
3. Head Assembly
Each machine is tested and inspected before being shipped. Any shipping damage incurred
is the responsibility of the carrier. You should notify the carrier immediately if you notice
damage to the box, to the machine or any parts.

INSTALLING NEW HEAD ASSEMBLY

For the initial setup, install the head assembly by:
1. Placing the head assembly and housing assembly on a flat surface (see Figure 3).
2. Unfastening the two fluted knobs on the head assembly (see Figure 3 and Figure 4)
Figure 3. Position Assemblies
Together, on Flat Surface
Note that the nozzle opening is facing outward during installation.
15 - TreadMaster Information and Operating Instructions
Figure 4. Fluted Knobs Removed
from Head Assembly; Nozzle Facing
Outward
Nozzle