Cleaning A Dry Filter; Cleaning A Wet Filter; Cleaning And Disinfecting The; Wet/Dry Vac - Workshop WS0500WM0 Mode D'emploi

mAINTeNANce (continued)

cleaning A Dry filter

NoTe: For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be done
outdoors and not in the living quarters.
1. Light cleaning of some dry debris from
the filter can be accomplished without
removing the filter from the Vac. Simply
slap your hand on top of the handle
while the Vac is turned off.
2. Remove filter from Vac. Gently tap the
filter against the inside wall of your dust
drum and the debris will loosen and
fall.
3. For thorough cleaning of a dry filter
with fine dust (no debris) you may run
water through it as described under
"Cleaning A Wet Filter" Section.

cleaning A Wet filter

After filter is removed, run water through
the filter from a hose or faucet. take care
that the water pressure is not too strong
to damage the filter. Allow filter to dry
before use or storage.

cleaning and Disinfecting the

Wet/Dry vac

To keep your Wet/Dry Vac looking its
best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e.; waste water pick up) the drum
should be disinfected.
To disinfect the drum:
1. Pour 1 gallon of water and 1 teaspoon
chlorine bleach into the drum.
2. Let solution stand for 20 minutes,
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the drum.
3. Empty drum after 20 minutes. Rinse
with water until bleach smell is gone.
Allow drum to dry completely before
sealing the motor on the drum.
4. After use, the Wall Mounted Wet/Dry
Vac may be stored on the wall bracket
as described on page 8.

Power cord

When your Wall Mounted Wet/Dry Vac is
not in use, it should be unplugged from
the outlet. Excess cord should be
wrapped over the hose storage rack.
If the power cord is damaged, it must be
replaced by the manufacturer or their
service agent or by similarly qualified
personnel to reduce the risk of accident.
WARNING: To assure product
sAfeTY and RelIAbIlITY, any other
maintenance, repairs or adjust-
ments should be performed by
Independent service centers,
always using WoRKshoP
replacement parts.
16