Videotec UCCMA Manuel D'instructions page 6

Connect the steel cables to the lower and upper
brackets as indicated in the following figures,
tightening with Loctite 238 (or equivalent). Fasten
with tightening torque of 4Nm.
Fig. 09
Fig. 10
The configuration in the figure is thus obtained.
Fig. 11
4
Half way along the length of the chain, insert the
supplied cable for wiring recovery, making it pass
through the 2 holes in the bracket.
Fig. 12
Turn the lower bracket overmaking it turn as in the
figure.
Fig. 13
Fig. 14