Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Troubleshooting
Problem
Possible Cause
Receiver status
Unable to bind receiver
LED flashes conti-
nously
No response
Transmitter switched off
after battery is
Transmitter batteries low voltage
connected to the
Poor contact on transmitter battery
helicopter
terminals
Motor does not
Helicopter battery low voltage
respond to throttle,
receiver LED
flashes
Main rotor spins
Throttle trim accidentally increased du-
after landing
ring flight
Servo moves, but
Throttle trim too high, safety function
motor fails
active
Throttle was not all the way down du-
ring power up
Loose motor connection or damaged
motor
Main rotor spins,
Deformed or broken main blades
but the helicopter
Helicopter battery low voltage
is unable to take
off
Strong vibrations
Deformed or broken main blades
Bent main shaft
Deformed or broken rear blades
Main blade greps overtigthening
XciteRC Flybar 190
Corrective Action
Repeat the Binding process, see chapter
BINDING
Switch transmitter ON
Replace transmitter batteries
Check battery terminals
Charge battery or replace with a fully char-
ged
Check throttle trim and set to neutral
Check throttle trim and set to neutral
Move the throttle stick all the way down
Check motor connectors or replace the
motor
Check and/or replace main blades
Charge battery or replace with a fully char-
ged
Check and/or replace main blades
Replace main shaft
Check and/or replace rear blades
Check screws and re-tight with suitable
force
EN
29
Publicité
Chapitres
Table des Matières
