Troubleshooting - XciteRC Eagle Monster Truck Mode D'emploi

Troubleshooting

• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!
Troubleshooting
Problem
Motor does not Drive battery empty
run
Motor broken
Weak motor / no Battery is almost empty
power
Drive train does not run smoothly
Vehicle is very loud
Motor gets very hot
Vehicle is hard to Transmitter LED off - transmitter batteries
control almost empty
Steering trim ST.TRIM on the transmitter
set incorrectly
Interference
Vehicle has no LEDs on the transmitter does not light up
function
Transmitter - receiver not bound
Interference
Transmitter LED off - transmitter batteries
almost empty
Drive battery empty
Vehicle runs very Worn gears
loud
Bearings runs tight or worn out
Eagle One16
Possible Cause Solution
Change or charge the battery
Replace the motor
Change or charge the battery
Check drive train and clean if necessary
Check pinion, replace if necessary
Allow motor to cool; check drive train for
binding parts and precise gear mesh
Change or charge the batteries
Check transmitter, set trim correctly
Turn off the vehicle and transmitter, make
a quick break and then re-try
Check that vehicle and transmitter are
turned on
Switch model and Transmitter off, then
on again (see chapter Getting started)
Set throttle trim to the center position
Change or charge the batteries
Change or charge the battery
Check and replace if necessary
Check and lubricate or replace if neces-
sary
EN
21