turck TX-EXTEND Mode D'emploi Simplifié page 3

TX-EXTEND
EN
Quick-Start Guide
TX-EXTEND – Extension module
For Your Safety
Intended use
TX-EXTEND is an extension module for the HMIs of the TX product family with
plug-in module.
The devices may only be used as described in these instructions.
Any other use is not in accordance with the intended use; Turck accepts no
liability for any resulting damage.
General safety instructions
■
The device may only be assembled, installed, operated, parameterized and
maintained by professionally-trained personnel.
■
The device only meets the EMC requirements for industrial areas and is not
suitable for use in residential areas.
■
The device may only be used in accordance with applicable national and
international regulations, standards and laws.
Product description
Dimensions
See fig. 1
Mounting
.
ATTENTION
Risk of short circuits
Destruction of electronic circuits!
Do not connect or disconnect when energized.
➤
Remove the protective cover.
➤ ➤
Mount the device according to fig. 2
➤ ➤
Maintenance
Clean the devicest in regular intervals with a damp cloth.
➤ ➤
Repair
The device must not be repaired by the user. The device must be decommis-
sioned if it is faulty. Refer to our return acceptance conditions when returning
the device to Turck.
Disposal
The devices must be disposed of correctly and must not be included in
normal household garbage
Approvals and standards
The products have been designed for use in Hazardous Location according
ANSI/ISA-12.12.01.
These products have been manufactured for industrial use in combination with
the HMIs of the TX... product family. Their operation complies with the provi-
sions of Directive 2014/30/EU.
Compliance
The products have been designed in compliance with:
■
EN 61000-6-2 and EN 61000-6-4
■
EN 61000-4-2 to EN 61000-4-6, EN 61000-4-8
■
EN 55011, Class A
■
EN 60945
ATTENTION
Operation in residential and commercial areas
Electromagnetic disturbances!
The device only meets the EMC requirements for industrial areas and is not
➤
suitable for use in residential areas.
Safety notes for the operation in hazardous areas (only approved in
USA and Canada, no ATEX Certification!)
NOTE
The Power, input and output (I/O) wiring has to be done in accordance with
Class I, Division 2 and in accordance with the authority having jurisdictions. For
U.S. in accordance with Article 501.10 (B) of the National Electrical Code, NFPA
70 and for Canada in accordance with Section 18-1J2 of Canadian Electrical
Code.
DANGER
Loss of Class 1, Division 2 approval in case of substitution of components
Danger to life due to risk of explosion!
Do not use components which do not comply with the Class 1, Division 2
➤
certification.
DANGER
Replacing or wiring modules under voltage
Danger to life due to risk of explosion!
Switch-off the device before replacing or wiring modules.
➤
DANGER
Disconnecting devices under voltage
Danger to life due to risk of explosion!
Do not disconnect devices under voltage, as long as they are installed in
➤
ignitable atmospheres.
NOTE
The devices are suitable for the use in Class 1, Division 2, groups A, B, C and D
(hazardous locations and non-hazardous locations).
© Hans Turck GmbH & Co. KG | 100005949 2019-06 DE EN FR