Fama TS 12 Manuel D'utilisation page 31

GRINDING GROUP ASSEMBLY / DISASSEMBLY
The assembly / disassembly operations of any machine part are performed with the stop machine and with the
plug disconnected from the socket, or with the sectioning device in OFF.
The grinding groups that can be foreseen, in accordance with the working requirements, can be: Enterprise, half Unger and
total Unger.
The grinding group Enterprise assembly on the machine takes place in two phases (in exemplifying way it is showed the
mincer with basic machine.
The phase n. 1 for the grinding group
Enterprise is performed on a working ground
following the under reported order:
1. Insert in the pipe union (1) in the order:
Archimedean screw (2), cutting knife
oriented as in figure and inserted in the
dragging pivot (3), drilled plate (4)
inserted in the pipe union place (1);
2. Screw down and tighten the blockage
wheel (5).
The phase n. 1 for the Half Unger grinding
group is performed on a work round following
the under reported order:
1. Insert in the pipe union (1) in the order:
Archimedean screw (2), first plate (3),
cutting knife oriented as in figure and
inserted in the dragging pivot (4), second
drilled plate (5) inserted in the pipe union
place (1), ring (6);
2. Screw down and tighten the blockage
wheel (7).
3
4
3
ORIGINAL INSTRUCTIONS TRANSLATION
4
Pag.
11
di
18