Use; Master Power Switch (Fig. E-2A) - Tunturi FitRun 50i Manuel De L'utilisateur

English
• Mobile phones, televisions and
other electrical appliances create an
electromagnetic field which can prevent
accurate heart rate measurement.
Maximum heart rate
(during training)
The maximum heart rate is the highest heart rate
a person can safely achieve through exercise
stress. The following formula is used to calculate
the average maximum heart rate: 220 - AGE. The
maximum heart rate varies from person to person.
!
WARNING
• Make sure that you do not exceed your
maximum heart rate during your workout.
If you belong to a risk group, consult a
physician.
Beginner
50-60% of maximum heart rate
Suitable for beginners, weight-watchers,
convalescents and persons who have not
exercised for a long time. Exercise at least three
times a week, 30 minutes at a time.
Advanced
60-70% of maximum heart rate
Suitable for persons who want to improve and
maintain fitness. Exercise at least three times a
week, 30 minutes at a time.
Expert
70-80% of maximum heart rate
Suitable for the fittest of persons who are used to
long-endurance workouts.

Use

Master power switch (fig. E-2A)

The equipment is equipped with a master power
switch to shut down the equipment completely.
To start the equipment:
- Insert the mains plug into the equipment.
- Insert the mains plug into the wall socket.
- Set the master power switch to the on position.
To stop the equipment:
- Set the mains power switch to the off position.
- Remove the mains plug from the wall socket.
- Remove the mains plug from the equipment.
20
Safety key (Fig F-4)
The equipment is equipped with a safety key that
must be properly inserted into the console to start
the equipment. If you remove the safety key from
the console, the equipment will stop immediately.
- Insert the safety key into the slot in the console.
- Make sure that the clip of the safety key is
properly attached to your clothing.
Make sure that the clip is not removed from
your clothing before the safety key is removed
from the console.
NOTE
• Console will show E7 code when safety
key is not in (correct) position during start
up.
Circuit breaker (Fig. E-2B)
The equipment is equipped with a circuit breaker
that interrupts the circuit when the electricity load
is above the maximum capacity. When this occurs,
the circuit breaker must be pressed.
!
WARNING
• Before pressing the circuit breaker, remove
the mains plug from the equipment.
If the equipment shuts down, proceed as follows
to restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the
equipment.
- Insert the mains plug into the equipment.
NOTE
• Some circuit breakers used in homes are
not rated for high inrush currents that can
occur when a treadmill is first turned on or
even during normal use. If your treadmill is
tripping the circuit breaker (even though it is
the proper current rating and the treadmill
is the only appliance on the circuit) but
the circuit breaker on the treadmill itself
does not trip, you will need to replace the
breaker with a high inrush type. This is not a
warranty defect. This is a condition we as a
manufacture have no ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1)
and folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of
unfolding and folding the equipment.