P72895_F1D104-OSD-univ_man.qxd
SCAN TIME:
Amount of time the OmniView
one port before switching to the next port when
in Scan Mode.
DISPLAY TIME:
Amount of time the OSD Menu or Port Name
remains displayed on-screen after making a
port selection.
NOTE: If there are slave units present, the SCAN TIME and DISPLAY TIME settings are set on
the MASTER unit only, and need not be set on the slave units.
The BANK/SCAN Button:
Pressing the BANK/SCAN button cycles you through all the active BANKs (if their slave
units present) and then puts the unit in AutoScan mode. If the unit is a single MASTER
unit, pressing the button immediately invokes AutoScan mode. This is evident by a
long BEEP, followed by two short beeps.
7/16/01
3:24 PM
Page 14
Usage
(continued)
™
PRO stays on
14
SCAN TIME:
7sec
15sec
30sec
DISPLAY TIME:
7sec
15sec
30sec
[ ]: SELECT
(INS):
RENAME
(Enter): COMPLETE
(Esc):
Exit
60sec
60sec