Belkin OmniView PRO Guide De L'utilisateur page 15

P72895_F1D104-OSD-univ_man.qxd
Selecting which computer to operate can be done either by On-Screen Display, the
CHANNEL button, or through keyboard "Hot" key commands. You will notice that after the
OmniView ™ PRO switches to another computer, the mouse will be inoperative for about 1-2
seconds. This is normal operation and ensures that proper mouse synchronization is
established.
The CHANNEL Button:
Pressing the CHANNEL button cycles you through all the ports, including inactive ports.
Keyboard "Hot" Key commands:
You can also conveniently command the OmniView
keyboard key sequences. To send commands to the OmniView
key must be pressed twice within 2 seconds. You will hear a beep for confirmation. Below
are the different commands:
You can switch directly to any port by giving the OmniView
numbers. For instance, if you press [SCROLL LOCK] [SCROLL LOCK] [2] [2], the computer on
PORT 2 of the OmniView
that is PC # 10. Hence, if you only have one OmniView
7/16/01 3:24 PM Page 11
Usage
1 2 3
Switch to PREVIOUS ACTIVE port
(on the same BANK)
Switch to NEXT ACTIVE port
(on the same BANK)
Switch to the PREVIOUS BANK
(by default, selects first active port on that BANK)
Switch to the NEXT BANK
(by default, selects first active port on that BANK)
Directly switches to port Y on BANK X.
(X = {0 to 3} g = {1 to 4})
Resets the OmniView ™
or a newly added slave unit.
PRO set to BANK 2 will be selected. In the following diagram,
™
11
4
™ PRO to switch ports through simple
™ PRO, the SCROLL LOCK
PRO to detect "lost" mouse, keyboard
™ PRO the BANK and PORT
PRO, the first key (X) must be "0".
™
En