Belkin OmniView PRO Guide De L'utilisateur page 10

P72895_F1D104-OSD-univ_man.qxd
PLEASE FOLLOW THIS INSTALLATION PROCEDURE EXACTLY. NOT
DOING SO MAY RESULT IN KEYBOARD AND/OR MOUSE ERRORS, OR
FAULTY OPERATION.
WARNING: Before attempting to connect anything to the OmniView
computers, make sure everything is powered off. Plugging and unplugging cables may
cause irreversible damage to your computers and the OmniView
will not be held responsible for damage caused.
1.
Set the DIP switches. If you have only one OmniView
setting. If the OmniView
unique slave setting. Please refer to the previous section for more information.
2.
Connect the monitor to the OmniView
included with your monitor, connect it to the HDDB15 female port on the back of the
OmniView ™
Monitor
7/16/01 3:24 PM
Hardware Installation
™ PRO you are using will be daisy-chained off another unit, use a
DIP SWITCH #
1 2 3
ON ON ON
ON ON OFF
ON ON ON
ON ON OFF
NOTE:"ON" is down
PRO labeled with the monitor symbol at the CONSOLE section.
Page 6
(continued)
™
™ PRO, use the MASTER bank
BANK ADDRESS
4
ON
BANK 0 MASTER
BANK 1 slave
ON
BANK 2 slave
OFF
OFF BANK 3 slave
™ PRO. Using the attached cable, or the one
6
™ PRO or the
PRO. Belkin Components