Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing a rear reflector on the seat post
1.
Loosen and remove the bracket screw (1) from the plastic bracket (3).
2.
Loop the plastic bracket (3) around the seat post (4).
3.
Begin to tighten the bracket screw (1) just enough to hold the reflector (2) in place. Adjust the reflector so that it
is in an upright position. Make sure the reflector is facing away from the bicycle.
4. Tighten the bracket screw (1) securely. If the bracket (3) is still loose, insert a shim inside to make it tight.
1
20
2
3
4
1.
Bracket screw
2.
Reflector
3.
Plastic bracket
3
4. Seat post
4
CAUTION: Ensure that the reflector is
vertical to the ground and facing straight
forward. If the reflector is aimed up or
down, incoming headlights may not
reflect properly on the reflector.
Publicité
Table des Matières
