Description - Lamborghini Caloreclima 55 PM/2-E Manuel D'installation Et D'entretien

● After removing the packaging materials, check the content integrity and make sure that no damages have
occured during transportation. In case of doubt, do not use the burner and contact the supplier.
The packaging material (wooden cages, cartons, plastic bags, foam, clips, etc...) are
potential sources of pollution and danger, if left lying around; they should be collected up and disposed of
in the correct way (in a suitable place).

DESCRIPTION

These are natural gas burners with a mix of gas/air to the combustion head and reduced capacity start-up.
The structure of the combustion head enables the use of all natural gases, mixes and liquids (consult technical
assistance for specific information). The gas/air mix makes it possible to obtain combustion with a low excess
of air, leading to a high combustion efficiency and low CO and NOx emissions, and consequently a low
environmental impact. They are suitable for pressurised and negative pressure furnaces, according to the
relative operating curves. With a long draught tube sliding on a flange, the burners make it possible to adapt
the length of the insertion to the requirements of the boiler. The gas train can be installed on the right or left (on
request). Complete access is easily achieved by means of the hinged opening between the casing and the
burner head, without removing the gas line connection. The burners operate automatically and have ionisation-
probe flame control.
The PM/2-E series burners have a two-stage operation with start-up in two-interval , and closing of air on
stopping. The burners are available with different valve sizes according to the gas flow rate required and the
gas pressure (and boiler) available.
37