Briteq BT-Laser1500 Mode D'emploi page 6

ENGLISH
DESCRIPTION:
1. MAINS INPUT: with IEC socket and integrated fuse holder, connect the supplied mains cable here.
2. MAIN ON/OFF SWITCH: used to switch the unit on/off.
3. COOLING FAN: used to cool the components inside the enclosure. Make sure to never cover this fan
outlet!
4. R-G-B: Laser output indicator for each color.
5. ILDA SIGNAL INDICATOR: RED = ILDA connected, GREEN = ILDA disconnected
6. ILDA INPUT: used to connect the laser to an ILDA certified interface of a computer, see further for more
information.
7. ILDA THROUGH: to link the ILDA signal to the next "BT-LASER1500 RGB" unit.
8. X SIZE CONTROL: use this control to adapt the width of the projected graphics to the dimensions of the
venue.
9. Y SIZE CONTROL: use this control to adapt the height of the projected graphics to the dimensions of
the venue.
10. MUSIC INPUT SENSITIVITY: This potentiometer is used to adjust the music input sensitivity. Turn the
potentiometer until the laser works in sync with the music.
11. SD CARD SLOT: used to insert the SD card with ILDA graphics for playback via DMX.
12. DISPLAY: shows the different working modes with their respective options and settings.
13. FUNCTION BUTTON: used to browse the different functions and working modes in the menu.
14. UP BUTTON: used to go to the upper option or to increase a parameter of a function or working mode.
15. DOWN BUTTON: used to go to a lower option or to decrease a parameter of a function or working mode
16. ENTER BUTTON: Used to confirm the selected value or function that is shown on the display.
17. INTERNAL MICROPHONE: The built-in microphone is used to synchronize the laser show to the beat of
the music.
18. DMX OUTPUT: 3pin female XLR-connector used to connect the laser with the next unit in the DMX
chain.
19. SAFETY EYE: used to attach a safety cable when the unit is
rigged (see paragraph "overhead rigging")
20. DMX INPUT: 3pin male XLR-connector used to connect universal
DMX-cables. This input receives instructions from a DMX-
controller.
21. INTERLOCK input: used to connect the optional emergency stop
switch (see picture). When you push this switch it will activate the
mechanical safety shutter so the laser beam will disappear
immediately.
BRITEQ
®
4/59
USER MANUAL
BT-LASER1500 RGB