Briteq BT-Laser1500 Mode D'emploi page 13

ENGLISH
6) OTHER SETTINGS:
 Press the FUNC-button (the display starts blinking) until the display shows SETTING
 Press the UP / DOWN buttons to browse the special setting options
 Press the ENTER-button to confirm the setting option you want to adapt:
 MIRROR: press the UP / DOWN buttons to set the desired image inverting mode. This can be
useful for example for projections behind a transparent screen
 COLOUR: press the UP / DOWN buttons to set the desired colour option: SINGLE COLOUR,
DUAL COLOUR or MULTICOLOUR
 MUSIC: press the UP / DOWN buttons to set the desired microphone sensitivity.
 Press the ENTER-button to confirm your choice. (the display stops blinking and the selected mode is
activated)
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans and ventilation openings should be cleaned
monthly.
 The interior of the device should be cleaned annually by experienced service people.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel only!
SPECIFICATIONS
Mains Input:
Fuse:
Total Power consumption:
Sound Control:
DMX connections:
DMX channels:
DMX starting address:
Laser Power:
Laser scanners:
Laser radiation class:
Laser Safety Standard:
Size (WxHxD):
Weight:
You can download the latest version of this user manual on our website: www.briteq-lighting.com
BRITEQ
®
AC 100~240V, 50/60Hz
250V 1.6A slow blow (20mm glass)
45W
Internal microphone
3pin XLR male / female
1 or 13 channels
001  500 or 511
200mW Green CW laser (λ = 532nm)
500mW Red CW laser (λ = 638nm)
800mW Blue CW laser (λ = 450nm)
high speed 20kHz type
Class 4
EN 60825-1:2007 for Laser Safety
30cm x 24cm x 16cm
7.86kg
Every information is subject to change without prior notice.
11/59
USER MANUAL
BT-LASER1500 RGB