Important; Dmx Mode - Briteq BT-Laser1500 Mode D'emploi

ENGLISH
4) SD CARD PLAYBACK:
You can install ILDA laser patterns and shows on the SD-Card. Once the SD-Card is installed in the laser,
you can recall and play the ILDA files via DMX. Like this you don't need a computer and ILDA cable
continuously connected to the laser.
 Press the FUNC-button (the display starts blinking) until the display shows SD SHOW
 Press the UP / DOWN buttons to choose one of the directory's (folder)
 Press the ENTER-button to confirm your choice
 Press the UP / DOWN buttons to choose one of the playback modes:
 PRG SHOW: The laser will run all the different shows that are in the selected folder continuously.
 ILD SHOW: The laser will run one single ILDA program of the folder continuously. Press enter to
select ILD show, then use the UP / DOWN buttons to select the specific ILDA program.
 Press the ENTER-button to confirm your choice. (the display stops blinking and the selected mode is
activated)

IMPORTANT:

 The SD-Card must be formatted in FAT32 !
 You can install maximum 100 folders with maximum 254 files in each folder.
 File name (and folder name) can have maximum 8 digits and 3 extensions like letter, numbers or
underscore.
 The systems only supports ILDA files with the "ild" extension. Don't store other types of files on the SD-
Card
 For a preprogrammed show, you have to include a Windows TXT file in the same folder as the patterns
you will use. Rename this TXT file to ".PRG"
o
EXAMPLE: you have 3 .ild files in a folder called TIGER (TIGER1.ild, TIGER2.ild and
TIGER3.ild)
o
To program a show with these files you need to write in the TXT file for example:
TIGER1.ild, 10,3
TIGER2.ild, 20,1
TIGER1.ild, 15,4
o
Save this TXT file and change the name TIGER.TXT into TIGER1.PRG
o
How does it work ?
For example: TIGER1.ild,10,3
TIGER1.ild = the ilda show name
"10" = scanner speed
"3" = the number of times this show should be repeated

5) DMX MODE:

The laser can be controlled by any standard DMX-controller in 2 different DMX-modes:
 1 CHANNEL MODE: for extremely easy setup and use! (display shows "DMX CH1")
 13 CHANNEL MODE: for full control of all possibilities. (display shows "DMX CH13")
 Connect the DMX input of the laser to the DMX output of the previous unit in the chain or directly to the
DMX-output of your controller.
 Press the FUNC-button until the display shows: DMX
 Press the UP/DOWN buttons to select the desired DMX-mode. (CH1 or CH13)
 Press the ENTER-button to confirm your choice.
 Press the UP / DOWN buttons to choose the desired DMX-address (from 001 to 500 or 511)
 Press the ENTER-button to confirm your choice.
Please refer to the DMX-chart below for the functions of the different channels.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected light effects with a good quality XLR M/F
balanced cable. To prevent strange behavior of the light effects, due to
interferences, you must use a 90Ω to 120Ω terminator at the end of the chain. Never
use Y-splitter cables, this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which
commands from the controller it has to decode.
BRITEQ
®
7/59
USER MANUAL
BT-LASER1500 RGB