Basic Operation - Tripp-Lite SmartPro SMART500RT1U Manuel De L'utilisateur

Basic Operation

LED Interface
Buttons (Front Panel)
"ON/OFF/STANDBY" Button
• To turn the UPS ON: with the UPS plugged into a live AC wall outlet*, press
• To turn the UPS OFF: with the UPS ON and receiving utility power, press and
* After you plug the UPS into a live AC outlet, the UPS (in "Standby" mode) will
"MUTE/TEST" Button
To Silence (or "Mute") UPS Alarms: briefly press and release the MUTE/TEST
button.*
To Run a Self-Test: with your UPS plugged in and turned ON, press and hold
the MUTE/TEST button for two seconds.* Continue holding the button until the
alarm beeps several times and the UPS performs a self test. See "Results of a
Self-Test" below. Note: you can leave connected equipment on during a self-test.
Your UPS, however, will not perform a self-test if the UPS is not turned on (see
"ON/OFF/STANDBY" Button description).
CAUTION! Do not unplug your UPS to test its batteries. This will remove
safe electrical grounding and may introduce a damaging surge into your
network connections.
13-12-130-93328A.indb 7
and hold the "ON/OFF/STANDBY" button for one second.** Release the
button. If utility power is absent, you can "cold-start" the UPS (i.e.: turn it ON
and supply power for a limited time from its batteries***) by pressing and
holding the "ON/OFF/STANDBY" button for one second.**
hold the "ON/OFF/STANDBY" button for one second.** Then unplug the UPS
from the wall outlet. The UPS will be completely OFF.
automatically charge its batteries, but will not supply power to its outlets until it is turned
ON. ** The alarm will beep once briefly after the indicated interval has passed. *** If
fully charged.
Results of a Self-Test: The test will last approximately 10 seconds as the
UPS switches to battery to test its load capacity and battery charge.
• If the "OUTPUT LOAD LEVEL" LED remains lit red and the alarm continues
to sound after the test, the UPS's outlets are overloaded. To clear the
overload, unplug some of your equipment and run the self-test repeatedly
until the "OUTPUT LOAD LEVEL" LED is no longer lit red and the alarm is no
longer sounding.
CAUTION! Any overload that is not corrected by the user immediately
following a self-test may cause the UPS to shut down and cease
supplying output power in the event of a blackout or brownout.
7
1/6/2014 2:59:23 PM