Optional Installation; Basic Operation - Tripp-Lite OmniSmart OMNI500ISO Guide De L'utilisateur

Optional Installation

USB Communication Port
This port can connect your UPS to any
computer for automatic file saves and
unattended shutdown in the event of
a power failure. Use with Tripp Lite's
PowerAlert Software and appropriate
USB cable. A PowerAlert
cable may be included with your UPS;
if so, insert the CD into the CD tray of
your computer and follow the installation
instructions. If PowerAlert Software and
a USB cable did not come with your
UPS, you can obtain the software FREE
via the Web at trip-plite.com. Any
user-supplied USB cable may then
be used to connect your UPS to your
computer. NOTE: This connection is
optional. The UPS will work properly
without this connection.

Basic Operation

Buttons
Use the ON/OFF button to do three things:
21-10-081 932490-Book.indb 4 21-10-081 932490-Book.indb 4
CD and USB
®
Switch your UPS's Operating Mode: While your UPS is plugged into
a live AC outlet, press the ON/OFF button and hold it until you hear
a beep (about 2 seconds) to toggle between the following operat-ing
modes. Choose your UPS's operating mode based on the regional
guidelines in Step 3 of the Quick Installation section.
• UPS Mode: ENABLES battery backup. UPS Conditions: The UPS
charges its battery and supplies power at its receptacles when
it is receiving utility line power. If utility power fails, the UPS
provides power from its batteries. The "
Setting Advantages: Provides battery backup during blackouts or
brownouts.
4
Model Shown: OMNI500ISO
" indicator light is lit.
10/26/2021 1:08:08 PM 10/26/2021 1:08:08 PM