Information Panel; Preventive Service Maintenance - Handicare RiseAtlas450M Mode D'emploi

Information panel

On the control panel at the bottom of the lift unit there are several symbols. The symbols lights up
when a function is activated. More information on each function is given below, and under chapter
Trouble-shooting.
Battery status
Battery status is indicated after 6 seconds when a lift unit with end point charging is activated, and
for 15 minutes if the in-rail charging option is used.
Service/maintenance
Information concerning service and maintenance. This symbol is activated once the lift unit has
been used for 12 months.
Overload protection
RiseAtlas is equipped with overload protection, which prevents the lift unit from lifting more than
the maximum rated load if this happen. A symbol for overload and a warning triangle light up and a
signal is heard. If this symbol is activated, the user is too heavy.
Read user manual
Often, the book symbol will light up at the same time as another symbol lights up, indicating that
the user should read the user manual before using the lift unit again.
Night light
RiseAtlas is equipped with night lighting, which will be activated by pressing and holding the ON
button on the hand control for 3 seconds. The LED lamp lights for 15 minutes if it is not inactivated
via the OFF button on the hand control.
Warning
The warning triangle is activated, prompting the user to read the user manual. Often, the warning
triangle will light up at the same time as another symbol lights up, indicating that the user should
read the user manual before using the lift unit again. Normally, a technician must be contacted
when this symbol is activated.
Preventative service/maintenance
The symbol for service/maintenance lights up automatically when the lift unit has been used for 12 months.
Contact an authorized Direct Healthcare Group service technician for maintenance and resetting.
16