Nibe RMU 40 Manuel Installateur page 21

Menu 2 - temporary lux
off
3 hrs
6 hrs
12 hrs
Setting range: 3, 6 and 12 hours and mode "off"
When hot water requirement has temporarily increased
this menu can be used to select an increase in the hot
water temperature to lux mode for a selectable time.
Caution
If comfort mode "luxury" is selected in the heat
pump/indoor module menu 2.2 no further
increase can be carried out.
The function is activated immediately when a time
period is selected and confirmed using the OK button.
The time to the right displays the remaining time at
the selected setting.
When the time has run out the menu returns to "from"
mode.
Select "off" to switch off
temporary lux 2
temporary lux .
Menu 3 - ventilation
normal
speed 1
speed 2
speed 3
speed 4
Setting range: normal and speed 1–4
Caution
This menu is only displayed for the exhaust air
heat pumps and ground source heat pumps
with the exhaust air module accessory (FLM).
The ventilation in the accommodation can be tempor-
arily increased or reduced here.
When you have selected a new speed a clock starts a
count down. When the time has counted down the
ventilation speed returns to the normal setting.
If necessary, the different return times can be changed
in the heat pump menu 1.9.6.
Menu 4 - op. mode
auto
manual
add. heat only
op. mode
Setting range: auto, manual, add. heat only
functions
Setting range: addition, heating, cooling
The heat pump/indoor module operating mode is
usually set to "auto". It is also possible to set the heat
pump/ indoor module to "add. heat only", when only
additional heat is used, or "manual" and then select
what functions are to be permitted.
Change the operating mode by marking the desired
mode and pressing the OK button. To select selectable
functions that are permitted or not, mark the function
using the arrow buttons and press the OK button.
ventilation 3
op. mode 4
addition
heating
cooling
GB
21