Nibe RMU 40 Manuel Installateur page 14

GB
Installing
RMU 40 cannot be installed directly against a wall be-
cause the connection terminal protrudes from the re-
verse.
Install RMU 40 either in a spare apparatus box or on
the plastic spacer supplied.
If you want to use the room temperature sensor in
RMU 40 the position of the room unit is important.
See section "Room sensor".
1.
Open RMU 40 by inserting a screwdriver in one of
the 4mm wide gaps in the edge. Press the screw-
driver straight in to open the clip. Repeat for the
other three clips.
2.
Without plastic spacer: Place the rear panel in front
of the apparatus box and screw to the wall.
With plastic spacer: Screw the plastic spacer into
the wall. Then screw the the rear panel into the
plastic spacer with the two screws supplied.
14
3.
Connect according to section "Electrical connec-
tion".
4.
Angle the front panel approx. 30° and secure the
two clips on one side. Then close the unit and se-
cure the two clips on the other side.