Fault Nding And Problem Solving - SEVERIN Fino Multi KA4566 Mode D'emploi

Fino Multi KA4566

6. Fault nding and problem solving

Fault
The appliance does not
operate after pressing the
Start/Stop button .
The display element Error
/ storage settings is
ashing.
Water is dripping from the
brewing unit.
The appliance performs
the brewing phase, but no
beverage is poured.
20
The table provided below will help you to solve potential problems
occurring during operation. In the event that you cannot nd a suitable
solution for a problem, please contact our customer service department, see
section "Customer service" on the last pages of this instructions document.
Cause
Maybe the appliance is not connected to
a power supply.
No strainer support assembled.
Bracket closure is open.
The water reservoir is empty or not
assembled or the water ll level is below
the mark MIN.
The valve at the bottom of the water
reservoir is clogged.
The oat used for ll level measurement
in the water reservoir is blocked.
The bracket closure was not closed
properly.
The strainer support is clogged.
The water reservoirs was not assembled
properly.
The water reservoir was removed during
the brewing process.
Remedy
Please check the connection line with
mains plug (K) for correct connection to
the mains supply.
Insert the required strainer support (C
to E). Then, press the Start/Stop button
.
Close the bracket closure (B). Then, press
the Start/Stop button .
Please ll the water reservoir (L)
appropriately and assemble. Then, press
the Start/Stop button .
Clean the water reservoir, see section
"5. Cleaning, care and maintenance".
Unblock the valve by slightly pressing
against it from underneath.
Then, press the Start/Stop button
Clean the water reservoir, see section
"5. Cleaning, care and maintenance".
Unblock the oat by lightly shaking the
water reservoir.
Then, press the Start/Stop button
Danger of scalding!
Immediately cancel the brewing process
by pressing the Start/Stop button
and wait until the display element
extinguishes. Carefully fold the bracket
closure (B) upwards, remove the strainer
support (C to E), check for faults/
irregularities and reassemble. Close the
brewing unit (A) by rmly pressing the
bracket closure (B) downwards.
Clean the water strainer support,
see section "5. Cleaning, care and
maintenance".
Please check if the water reservoir (L) is
assembled properly.
Reassemble the water reservoir (L) and
continue or repeat brewing process.
.
.