Initial Start-Up - SEVERIN Fino Multi KA4566 Mode D'emploi

2. Initial start-up

Before initial use the following advice list must be observed.
– Rinse all strainer supports with warm water.
– Plug in the connection line with mains plug (K) to the mains supply.
– Remove the water reservoir (L) and rinse thoroughly with water and ll
with fresh, cold water up to the mark MAX (approx. 900 ml).
– Place the water reservoir (L) straight onto its support and press it
downwards completely so that the valve in the bottom of the reservoir
is opened.
– Place a cup with a minimum capacity of 150 ml onto the drainage grille
(G).
1. Open brewing unit (A). For this purpose, fully fold the bracket closure (B)
upwards.
2. Then take the strainer support for co ee pads (C) and place it into the
brewing unit.
3. Close the brewing unit (A) by rmly pressing the bracket closure (B)
downwards.
4. Press the Start/Stop button (H.5)
ashing. After a short heat-up phase the cleaning process is started and
the cup is lled with water.
Important: When the display element (H.1)
!
acoustic signal is generated the cup must be emptied and step 4 must
be repeated. Then, the appliance is ready for operation.
. The display element
extinguishes and an
EN
(H.1) is
7