Technical Data; Led Torch; Care And Cleaning - VOLTCRAFT PB-20S Mode D'emploi

• Briefly press the function switch (1) to display the
internal rechargeable battery level. The remaining
capacity of the rechargeable battery is indicated
by the lit LEDs as follows:
1 LED: Remaining capacity up to 25%
2 LEDs: Remaining capacity up to 50 %
3 LEDs: Remaining capacity up to 75 %
4 LEDs: Remaining capacity up to 100 %
• Open the rubber cover (3). Use the included USB charging cable to connect the Micro-USB
plug to the Micro-USB input (5).
• Connect the USB-A plug to a suitable USB power source (for example, a USB power adapter
with 2000 mA output current). The charging time is about 12 - 13 hours.
• You can also charge the internal rechargeable battery via the USB-C
supplied USB-C charging cable with a charging current of max. 3000 mA. The charging
TM
time is about 7 hours.
The internal battery of the power bank cannot be charged at the same time on the
Micro-USB input and USB-C
flows.
• The battery level indicator (2) flashes during charging.
0 – 25 % 25 – 50 %
LED 1 Flashes blue Solid blue
LED 2
Off Flashes blue
LED 3 Off
LED 4 Off
• As soon as the internal battery is fully charged, all 4 LEDs glow steadily.
• Disconnect the charging cable from the product and from the power source as soon as the
internal rechargeable battery is fully charged. The product is ready for use.
If you only use the product occasionally, we recommend that you fully charge the
internal rechargeable battery every 6 months in order to retain maximum capacity.
Charging mobile devices
• Open the rubber cover and connect your mobile device to one of the USB outputs.
• The battery level indicator glows steadily and indicates the current charge level of the power
bank.
You can charge up to 3 devices at a time. The maximum charging current is 3 A.
The charging currents of the USB outputs can be found in "Technical data". Check
the charging current of your mobile device.
The internal rechargeable battery can be charged while mobile devices are being
charged.
The internal rechargeable battery must be sufficiently charged so that 2 or 3 devices
can be charged at a time.
• Monitor the charging process. Disconnect the USB charging cable from the product and the
mobile device to interrupt or stop the charging process.
• Close the rubber cover to protect the product from dust and water.
If the internal rechargeable battery level becomes too low, the product will turn off
automatically to prevent excessive discharge of the internal rechargeable battery.

LED torch

• Switch on the LED torch (7) by double-clicking on the function switch. The torch glows with
100% brightness.
• Then press the function switch once to switch to 20% brightness.
• Press again to turn on the blinking light. Press the function switch again to turn off the torch.
• You can switch the torch to SOS signal. To do this, switch on the torch by double clicking and
then hold the function switch pressed for 3 seconds.
• Press the function switch again to turn off the SOS signal.

Care and cleaning

• Disconnect the product from all the connected devices before cleaning. Close the rubber
cover.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may
damage the casing or cause the product to malfunction.
• This product does not contain any components that require maintenance. Never attempt to
open or disassemble it.
• Use a lint-free cloth to clean the product.
• Dust can be easily removed using a soft and clean long-haired brush.
LED: 1 2
TM
input. If both inputs are occupied, no charge current
TM
50 – 75 % 75 – 99 %
Solid blue Solid blue
Solid blue Solid blue
Off Flashes blue Solid blue
Off Off Flashes blue
Disposal
Electronic devices are recyclable waste and must not be placed in household
waste. At the end of its service life, dispose of the product according to the relevant
statutory regulations.
You thus fulfil your statutory obligations and contribute to environmental protection.

Technical data

Input voltage/current ..................... Micro-USB: 5 V/DC 2 A
3 4
Output voltage/current .................. 2x USB-A: 5 V/DC 2.4 A each port
Rechargeable battery ................... Li-Ion, 20100 mAh 72.36 Wh
input (6) with the
LED torch ...................................... 1 W, 120 lumens, colour temperature 6000 - 6500 K
Protection class ............................ IP67
Operating/storage temperature .... 0 to +45 °C
Operating/storage humidity .......... <80% RH (with rubber cover open)
Dimensions (L x W x H) ................ 160 x 90 x 29 mm
Weight .......................................... approx. 491 g
100 %
Solid blue
Solid blue
Solid blue
Solid blue
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or capturing in
electronic data processing systems) requires prior written approval from the publisher. Reprinting, also in part, is
prohibited. This publication reflects the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE.
USB-C : 5 V/DC 3 A
TM
USB-C : 5 V/DC 3 A
TM
max. 3 A for all USB outputs together
*2149348_v2_0821_02_dm_mh_en