Operating The Chainsaw; Switching On; Checking The Chain Brake - Deltafox DG-ECS 2240 Traduction De La Notice D'utilisation Originale

GB
C
1. Unscrew the oil fill cap (2) and fill
up with chain oil.
2. Wipe off any spilled oil and close
the cap (2) again.
Always switch off the device and
allow the motor to cool before
filling with chain oil. There is a
risk of fire if oil overflows.

Operating the chainsaw

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled. Ensure the voltage of
the mains connection agrees with
the label on the device. Make sure
you have a secure stance. Make
sure before you start that the elec-
tric chain saw is not touching any-
thing.
Caution! Saw can oil up, see notes
on "Assembly - Mounting the saw
chain and blade"

Switching on

1. Check before the start, whether
D
sufficient chain oil is in the tank
and, if necessary, refill with
chain oil (see Chapter Operation
Startup).
2. Form a loop from the end of the
extension cable and hang this
into the tension relief (11) on the
rear grip (1).
3. Connect the device to the mains
voltage.
4. Release the chain brake, where
you shift the brake arm (3) back
against the front grip (16).
5. Hold the electric chainsaw firmly
44
with both hands, with the right
hand on the rear grip (1) and
the left hand on the front handle
(16). Thumb and finger must
close securely over the handles.
6. For switching on, activate the
switch-on block (14) with the right
thumb and then press the On/
Off switch (13), the electric power
saw runs with highest speed.
Release the switch-on block (14)
again.
7. The power saw switches off
when you release the On/Off
switch (13) again. Switching for
continuous running is not pos-
sible.

Checking the chain brake

The motor cannot be turned on if
the chain brake has engaged. Do
not employ the chain brake in order
to start the chainsaw or to switch it
off.
E 1. Place the electric chainsaw onto
a solid, flat surface. It must not
contact any objects.
2. Connect the device to the mains
voltage.
3. Release the chain brake by
shifting the brake arm (3) over
against the front grip (16).
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear handle (1) and
the left hand on the front handle
(16). Thumb and finger must
close securely over the handles.
5. Turn on the electric chainsaw.
6. Activate the chain braking lever
(3), with running motor, with the
left hand. To do so, push the