Basic Repairs; Rear Light Integrated In The Battery In The Rear Carrier; Replacing The Front Wheel In Fds Bicycles / Disconnecting The Motor's Cable; Replacement Of The Rear Wheel With The Rds System / Disconnection Of The Motor Cable - BH Easy Motion Neo Manuel De L'utilisateur

EN
U S E R M A N U A L

BASIC REPAIRS

Rear light integrated in the battery in the rear carrier

Due to road safety, the energy used for the rear light is independent from the pedal assistance system. The rear light
works with AA 1.5 V batteries.
The rear light switches on (1) and off (2) by pushing the button as illustrated below:
In order to replace rear light batteries, the user shall operate the battery away from the rack. Firstly, the user will
unscrew the three screws which hold the rear light (1). This way the battery may be separated from the light and the
batteries replaced by new ones (2)

Replacing the front wheel in FDS bicycles / Disconnecting the motor's cable

The motor is located at the front wheel's axis. When separating the front wheel, the user shall make sure to disconnect
the motor's cable. For this purpose, the pedal assistance must be switched off.
The user shall unscrew the two screws that attach the protection casing to the fork (1). The user shall separate the cover
from the protection casing (2) and disconnect the motor's connection to the pedal assistance system (3).

Replacement of the rear wheel with the RDS system / disconnection of the motor cable

To replace the back wheel you must disconnect the cable from the joint located behind the rear chainstay (1). Unscrew
the nut and also remove the rear washer, taking care to leave the opening of the black tube facing downwards (2).
Unscrew the nut on the left side (3), as well as the safety clamp, to be able to remove it (4). You can now take off the
wheel, replace it with a new one, and then repeat the process in reverse.
3 1