System Error Indicator - BH Easy Motion Neo Manuel De L'utilisateur

EN
U S E R M A N U A L
7. Selection of the wheel measurement
At any moment, the user may change the size of the wheel by pressing at the same time (-) and (+) buttons for 1
second. As a result, the dimension of the wheel's perimeter shall be displayed on the console; the measurement is
expressed in millimetres and its equivalency is displayed in inches (16, 20, 24, 26, 27 or 28). This dimension may be
changed by pressing buttons (+) and (-).
The measurement method used on the wheel's perimeter is as follows:
Perimeter of the wheel (mm) = Diameter of the wheel (D in mm) x 3.14
D (mm)
8. Throttle function up to 6 km/h
The BH EMOTION system has an integrated throttle function included in the control console which limits speed to a
maximum of 6 km/h, in accordance with the EN 15194 Regulation. To activate the system's throttle, the user shall press
the (+) button for at least 3 seconds and provide the bicycle with small initial push. To cancel the throttle function the
user shall stop pressing the (+) button.
9. Accelerator function up to 20 km/h (exclusive to the Neo Nitro model
The Neo Nitro model will incorporate an accelerator, with a maximum speed of 20 km/h, on the right handlebar
grip.

10. System error indicator

The BH EMOTION system continuously verifies its state. It is an intelligent system which is continuously checking the
state of the different elements which comprise it.
The system error indicator is activated in the control console when a system failure occurs. When this happens,
make sure that the battery is charged, stop the motor and start it again by pressing the POWER button, taking special
precaution in not applying force on the pedal. If the problem persists, stop the motor and contact a BH dealer.
The table in page 35 describes possible operation errors.
2 6