Settings And Functions - Marvel MP36BF2 Mode D'emploi

Settings and Functions

I n order for your new refrigerator to work properly, it is important that you understand its various features, controls, and
how to use them.
Power On/Off Switch (Power Interruption Switch)
The power on/off switch is located behind your refrigerator's top grille. It is used to turn the power off when cleaning the
refrigerator or changing the light bulbs. Your refrigerator arrives from the factory with the power interruption switch on.
To turn power off, remove the center grille louver. Press the power on/
off switch to the off position.
To turn power on, press power on/off switch to the on position. Replace
the center grille blade.
IMPORTANT: Be sure the power on/off switch is in the on position after cleaning or changing light bulbs.
Showroom Mode Initiation
Showroom mode allows electronic controls and interior lights to function independently of refrigeraton system.
To enter the showroom mode: Press and hold "ACTIVATE CONTROLS" pad; while holding, press and hold the "HIGHER"
and "ALARM OFF" pads together for 3 seconds. Three beeps will sound and SHOW will be lit. Showroom mode is
entered.
To exit the showroom mode: press and hold "ACTIVATE CONTROLS" pad; while holding, press and hold the "HIGHER"
and "ALARM OFF" pads together. Three beeps will sound and control will revert to normal operation and display.
Electronic Temperature Settings
Your refrigerator's electronic controls are located behind the door above the cabinet interior. To activate the electronic
control panel, press "ACTIVATE CONTROLS" pad. All other pads, except the "ALARM OFF" pad, will remain inactive until
the "ACTIVATE CONTROLS"pad is pressed. Once activated, pad remains programmable for at least ten minutes.
When you fi rst plug your new refrigerator in, you will fi nd that the refrigerator is factory set at 38° F in the refrigerator and
0° F in the freezer. Wait 24 hours after plug-in for the cabinets to reach this setting. After 24 hours, you may adjust controls
as desired.
To change from °F to °C, press and hold "ACTIVATE CONTROLS" then press and hold "ALARM OFF" for 3 seconds. To
change back, follow the same steps.
To adjust the refrigerator or freezer temperature, simply press the "ACTIVATE CONTROLS" pad, then "Ref Temp" pad or
"Frz Temp" pad. Press the "HIGHER" or "LOWER" pad to adjust temperature setting one degree at a time.
Note: Allow 24 hours for temperature to reach desired setting after any change in set temperature.
FREEZER FREEZER REFRIGERATOR REFRIGERATOR
F
C
MAX FRZ MAX REF MAX FRZ MAX REF
FAST COOL FAST COOL
SAB SHOW SAB SHOW
6
DOOR OPEN DOOR OPEN
POWER POWER
HIGH TEMP HIGH TEMP
Power
Switch