Care And Cleaning And Energy Saving Tips - Marvel MO24RF Instructions D'installation, D'utilisation Et D'entretien

CARE AND CLEANING AND ENERGY SAVING TIPS

Soak up
water from
plastic drain
pan if
necessary
Figure 21
Remove screws
around perimeter
of access cover.
CAUTION
!
The water supply to the ice-maker must be turned on prior
to turning the ice-maker on. Failure to do so will cause
rapid dry cycling of the ice-maker mold heater resulting in
temperature control issues in the freezer compartment.
Energy saving tips:
The following suggestions will minimize the
cost of operating your refrigeration appliance.
1. Do not install your appliance next to a hot appliance
(cooker, dishwasher, etc.), heating air duct, or other
heat sources.
2. Install product out of direct sunlight.
3. Ensure the front grille vents at front of appliance be-
neath door are not obstructed and kept clean to allow
ventilation for the refrigeration system to expel heat.
4. Plug your appliance into a dedicated power circuit. (Not
shared with other appliances).
5. When initially loading your new product, or whenever
large quantities of warm contents are placed within
refrigerated storage compartment, minimize door
openings for the next 12 hours to allow contents to pull
down to compartment set temperature.
Start-Up After Long-Term Storage:
1. If stored outside, it is recommended that the unit again
2. Connect the unit to electrical power and the water sup-
3. Turn unit on and confirm your desired control settings.
4. Allow 24-hrs for the unit to stabilize before loading
Solenoid
cover and
3 screws
Clean out
debris
Access cover
To disconnect the water outlet line: Push up on the white
collar and pull the plastic water line from the bottom of the
water valve.
To reconnect the water outlet line: Simply insert the plas-
tic tubing into the white collar and push until it stops (about
⁄ ", 12 mm, of water line will enter the valve).
1
2
6. Maintaining a relatively full storage compartment will
7. Ensure door closing is not obstructed by contents
8. Allow hot items to reach room temperature before plac-
9. Minimize door openings and duration of door openings.
10. Use the warmest temperature control set temperature
11. When on vacation or away from home for extended pe-
12. Set the control to the "off" position if cleaning the
19
be thoroughly inspected per the storage instructions
above to address any dirt or debris from the weather
and/or animals/insects.
ply.
contents.
Figure 21a
Plastic outlet
water line
require less appliance run time than an empty compart-
ment.
stored in your appliance.
ing in product.
that meets your personal preference and provides the
proper storage for your stored contents.
riods, set the appliance to warmest acceptable tem-
perature for the stored contents.
appliance requires the door to be open for an extended
period of time.
White
collar